Product Description

• Chevy/Jeep spindle bolt pattern accepts "outers" from all open knuckle Chevy and Jeep Dana 44, Dana 30, and 10-bolt front ends to 1986
• Based on our Heavy Duty Chevy Dana 44 knuckles
• Cast from high strength ductile iron
• Beefed up with extra material and ribbing
• Designed to be a direct replacement for a passenger side Chevy Dana 44 knuckle
• Flat tops machined and drilled for 3-hole high steer arms, not raised the additional 3/8" for high steer tie rod to leaf spring clearance as are our other Dana 44 knuckes.
• Cast-in DUAL steering stops eliminate bent stop bolts that can cause u-joint and axle failures
• Top-to-bottom tapered tie rod hole accepts factory tie rod ends
• Tie rod hole can be drilled to accept 3/4" heim ends
• Available with or without bright orange powder coating
• Fully machined and ready for installation
• Machined to clear CTM u-joints without removing the grease fittings

Will fit 10-bolt and early Dana 30 axles with minor modification.